Articles
Ralf Deuke of Creabis in conversation with Hugo Ploegmakers at Formnext 2022
During this interview, Hugo asked his view about Additive Manufacturing industry, the importance of workflow automation, quality control and the cooperation with AM-Flow.
Scaling up Serial Additive Manufacturing production with Buffer Units
Buffer Unit combined with VISION, and SORT ensures that parts are stored safely and securely, ready for use in the next stage of production.
e-Book article | How automated post-printing makes scalable AM production viable
AM-Flow’s automated solution for part identification and sorting drives down the cost-per-part of 3D printing, enabling scalability like never before.
The Relevance of Cost Per Part to Scale the Additive Manufacturing Industry
What is holding additive manufacturing back from broad industrial adoption and scalability? A lot of it comes down to cost, and this is still too high…
Anthony Graves (HP 3D Printing) in conversation with AM-Flow at Formnext 2021
During this interview, Carlos informs about Anthony’s vision, experiences and developments within the additive manufacturing industry alongside traditional manufacturing companies.
Intelligent System Solutions with Autonomous Mobile Robot: AM-Flow and OMRON
Intelligent System Solutions with Autonomous Mobile Robot: AM-Flow and OMRON
AMFG | Industrialising Additive Manufacturing: 3 Key Trends in 2021
Additive manufacturing relies on three elements: design, production and post-processing. What are the current trends within each of these areas and how are they evolving to support the industrialisation of 3D printing?
Podcast QRM4.0 bij AM-Flow met Ronald Scheer en Dennis Lieffering
Ronald Scheer van Fontys Hogeschool Eindhoven in gesprek met Dennis Lieffering, Markering Manager bij AM-Flow over het belang van automatisering binnen Additive Manufacturing
BMW study: Faster identification and part sorting time of a 3D build job thanks to AM-Vision
BMW research explores value of AI for automated AM part identification in automotive. AM-Flow’s AM-VISION identified as next step towards large-scaled AM production
4 Promising Automation Trends In Additive Manufacturing
Where are we today in terms of automation in additive manufacturing? The article written by AMFG highlights four key trends driving the development of automation solutions in AM.
Additive Manufacturing: Is now the time for industry to embrace 3D printing?
Listen to the recorded expert panel discussion with Lee-Bath Nelson, Yann Rageul and Carlos Zwikker, moderated by Chris Beck exploring what manufacturers should consider when it comes to effectively deploying AM to increase efficiencies throughout the entire workflow, while decreasing the vulnerability of the production chain.
Automation in 3D printing post production is key to success
Almost everywhere, 3D-printed parts are still manually identified, sorted and finished. According to Dennis Lieffering, this can be done faster and better via automation that uses sensors, data and AI.
DPA | Automating post-production to scale up additive manufacturing
Stefan Rink, CEO AM-Flow explains how post-processing software and hardware enables 3D printing to become a fully digital, fully connected part of the factory of the future.
AMS 2021: The Gaps in Automating 3D Printing for Production
Recap AMS 2021: The Gaps in Automating 3D Printing for Production by by Michael Molitch-Hou | 3DPrint.com
TCT Podcast Additive Insight: AM-Flow talks demand for additive manufacturing workflow automation
TCT Podcast #53 | Additive Insight: AM-Flow talks demand for additive manufacturing workflow automation. Carlos Zwikker, CCO at AM-Flow joins the pod to talk #additivemanufacturing workflow automation.
